When direct-buried anchor bolts (ie dead bolts) are used, a certain length of casing (PVC pipe) should be installed. In this way, on the one hand, the constraint can be reduced, leaving a space for plastic elongation for the high-strength anchor bolts; on the other hand, the surface of the bolt can be protected from being scratched. The anisotropy in the hot-worked forged material is relatively strong. Therefore, for the blank of the anchor bolt having a relatively large diameter, a round steel in a rolled state should be used. When using forgings, it is important to note that there is a sufficient forging ratio. When machining for machining, pay attention to the reasonable arrangement of the process, the balance between the processes and the heat treatment between the processes to reduce the machining stress, machining cracks, and the like. The thread is rolled and the turning is not used as much as possible, which not only maintains the continuity of the fiber, but also avoids stress concentration at the root of the thread. Non-destructive testing Proper non-destructive testing should be arranged between machining operations, such as magnetic particle inspection, ultrasonic flaw detection, etc., to determine whether the degree of surface cracks or internal defects of the workpiece is within the allowable range.
Standards must fully understand the guiding role of various standards in design and manufacturing. Although there is no national standard for high-strength anchor bolts, the national standard has clear provisions for high-strength bolts for steel structures, and it is helpful for the selection of high-strength anchor bolts. The breakage of the anchor bolts is a low stress brittle fracture caused by insufficient toughness. Improper material selection is fundamental, and the wrong heat treatment and installation prompts it to happen. The selection of high-strength steel materials should pay more attention to the matching of strength and toughness. The quenched structure should be low carbon martensite or lower bainite. Attention should also be paid to the size effect of the material. Parts of high-strength steel materials should be considered in terms of design, manufacture, installation, etc. in order to be effective.
Product categories of C/Z/U/M Purline Roll Forming Machine ,we are specialized
manufacturers from China , C/Z/U/M Purline Roll Forming Machine,sheet rollforming machine,
suppliers/factory,wholesele high-quality product of C/Z/U/M Purline Roll Forming Machine,
R & D and manufacturing , we have perfect after-sales service and technical support . Look forward
to your cooperation !
C/Z/U/M Purline Roll Forming Machine
Purlin Roll Forming Machine,M Purline Roll Forming Machine,Z Purlin Roll Forming Machinery,C Purlin Roll Forming Machinery
BOTOU HUATONG CORRUGATED MACHINERY MANUFACTURING CO.,LTD , https://www.htrollforming.com